Hydraulic Motors

Hydraulic Motor Type: OM

- with high torque

- Connection thread G 1/2”
- Drain line connection G 1/4” (required at pressures over 10bar in the return line)
- Inlet pressure: 140 bar (intermittent up to 175 bar)
- Runs uniformly at low speed (approx. 10 R/min)
- Driveshaft is loadable radial and axial
- Applicable for both rotation directions
- Interchangeable with OMP und OMR motors
- Cylindric shaft (on request with SAE shaft)

Hydraulic Motor with PTO Type: OMS

- Hydraulic motor with high torque
- Applicable for both rotation directions
- Connection G1/2”
- Drain line connection G1/4” (required at pressures over 10bar in the return line)
- Inlet pressure 210 bar (intermittent up to 250 bar)
- Shaft with power take-off profile 13/8” (Ø 34,9 mm)
- Runs uniformly at low speed (approx. 10 R/min)
- Drive shaft is loadable radial and axial

Hydraulic Gear Motor

High-speed Motor

- Oil connection (4-bolt-flange), inlet LK 35, return flow LK 40 mm
- Max. outlet pressure: 5 bar
- Power take-off should be done by elastic coupling
- It must not transfer radial or axial forces to the motor shaft
- Application: e.g Fans

Dual crossover relief valve

This Valve gets flanged directly to a Hydraulic motor Type: OM and serves to protect the motor against overpressure (generally max. 175 bar).

Usage:

To limit engine torque. (Clock- and anticlockwise rotation can be adjusted seperately )

Splined shaft with power take-off profile

To slip over the cylindric shaft (Ø 25 mm) on the hydraulic motor.

Sleeve with Power Take-Off Profile

To slip over the cylindric shaft (Ø 25 mm) of a hydraulic motor.